Version 1.0.241

27 settembre 2026

These are the notes published with this version in the App Store.

Rules

• A new Rules tab on the calendar: trigger on grid voltage, battery level or tomorrow's forecast, and choose to change an inverter setting, send a notification, or both.
• Start from a ready-made template, or build your own. The notification names the condition that fired and the limit you set.
• Each rule keeps a history of when it fired. Drag automations into the order that decides between them.

Several Edge connectors per household

• Add a second board, or replace a board, from the Edge devices screen. Setup can handle several boards in one pass.
• Each board shows its Wi-Fi signal in the list, on its own page and during setup.
• Setup now finds LuxPower SNA and PI30 (Edecoa) inverters on the board's RS-485 cable.
• A board that was reset with its button can be set up again and returned to its station.

Batteries

• Adding a battery monitor is one guided flow that ends on a real reading. The app identifies the protocol from the pack itself, and you can still choose it yourself.
• Packs are shared between boards by signal strength, and each pack shows which board reads it and which battery bank it belongs to.
• The cell list shows each cell's deviation from the average.

Smart devices and Zigbee

• Group devices by room, and choose what a socket does when power comes back.
• A metering socket shows what it draws now and what it drew today. Smart devices have their own chart on the main screen.
• Add Zigbee devices one at a time, move a device to another hub, or reset the whole mesh and start over.
• A slow switch says why, and a failed pairing names the cause.

Smaller fixes

• A parallel station shows its grid from the master inverter, and its battery layout no longer overlaps.
• The dashboard refreshes when the next reading is due, and its age label keeps ticking.