Flash your Svitgrid Edge

One click. No terminal. No esptool download.

⚠ Browser not supported. In-browser flashing needs Chrome, Edge, Opera, Brave, or Arc. Open this page in one of those browsers to continue.

Plug the Edge into your computer with a data USB-C cable — a direct port, not a hub
Hold BOOT, tap RESET, release BOOT
Click the button below and pick your Edge from the device list
Wait ~30 seconds without unplugging — done

⚡ Before you start: use a known-good data USB-C cable (many cables are charge-only) in a direct port on your computer, not a hub — a weak cable is the #1 cause of a failed flash. Once flashing begins, do not unplug or press any buttons until it says done (~30 s).

Troubleshooting

Button is greyed out or does nothing

The Flash button needs WebSerial, which only works in Chromium-based browsers (Chrome, Edge, Opera, Brave, Arc) on a desktop. If you are on Safari or Firefox, open this page in Chrome or Edge instead.

"No device found" in the picker

Make sure the USB-C cable carries data (not just power — some cables are charge-only). Then hold the BOOT button, tap RESET, release BOOT, and click Flash now again.

Flashing failed, or the device seems dead afterward

Your device is not damaged. A failed or interrupted flash can never permanently brick an Edge — it just needs to be flashed again. This is almost always a weak USB cable dropping the connection mid-write. Switch to a different data USB-C cable in a direct port (avoid hubs and charge-only cables), redo the BOOT/RESET sequence, and flash again. It will recover.

Device boots but won't connect to Wi-Fi

Flashing is done — your Edge is running fresh firmware. Wi-Fi pairing is a separate step done through the Svitgrid mobile app. See the onboarding guide.

Want to see your device's logs?

Open the log viewer to watch live logs from your Edge over USB-C — handy when reporting an issue to support.